Version 6.2 207 February 2011
SIP User's Manual 5. EMS-Based Management
5.7 Provisioning SIP MLPP Parameters
This section describes how to configure the MLPP (Multi-Level Precedence and
Preemption) parameters using the EMS.
¾ To configure the MLPP parameters:
1. In the Navigation pane, select VoIP > SIP, and then in the Configuration pane,
select SIP Advanced Configuration; 'SIP Advanced Configuration' frame appears.
2. Select the MLPP tab; the 'MLPP' screen appears.
3. Configure the MLPP parameters as required.
Note: If the following RTP DSCP parameters are set to “-1” (i.e., Not Configured,
Default), the DiffServ value is set with the
PremiumServiceClassMediaDiffserv global gateway parameter, or by using IP
Profiles: MLPPRoutineRTPDSCP, MLPPPriorityRTPDSCP,
MLPPImmediateRTPDSCP, MLPPFlashRTPDSCP,
MLPPFlashOverRTPDSCP, MLPPFlashOverOverRTPDSCP,
MLPPNormalizedServiceDomain.
To Next Page
Loading...
