AudioCodes MediaPack MP-124 User Manual

SIP User's Manual 50 Document #: LTRT-65415
MediaPack Series
3.1.9 Creating a Login Welcome Message
You can create a Welcome message box (alert message) that appears after each
successful login to the device's Web interface. The ini file table parameter
WelcomeMessage allows you to create the Welcome message. Up to 20 lines of character
strings can be defined for the message. If this parameter is not configured, no Welcome
message box is displayed after login.
An example of a Welcome message is shown in the figure below:
Figure 3-22: User-Defined Web Welcome Message after Login
Table 3-2: ini File Parameter for Welcome Login Message
Parameter Description
WelcomeMessage
Defines the Welcome message that appears after a successful login to the
Web interface. The format of this parameter is as follows:
[WelcomeMessage]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text;
[\WelcomeMessage]
For Example:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text;
WelcomeMessage 1 = "*********************************";
WelcomeMessage 2 = "********* This is a Welcome message **";
WelcomeMessage 3 = "*********************************";
[\WelcomeMessage]
Note: Each index represents a line of text in the Welcome message box.
Up to 20 indices can be defined.

AudioCodes MediaPack MP-124 Specifications

General

Model	MediaPack MP-124
Category	Gateway
Protocols	SIP, H.323, MGCP
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Fax Support	T.38
Management	SNMP
Security	TLS/SRTP
Power Supply	100-240 VAC, 50/60 Hz
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-25 to 70°C
Humidity	10% to 90%, non-condensing
Analog Ports	24 FXS