SIP User's Manual 376 Document #: LTRT-65415
MediaPack Series
Parameter Description
Web/EMS: Mutual Authentication
Mode
[MutualAuthenticationMode]
Determines the device's mode of operation when
Authentication and Key Agreement (AKA) Digest
Authentication is used.
[0] Optional = Incoming requests that don't include AKA
authentication information are accepted (default).
[1] Mandatory = Incoming requests that don't include AKA
authentication information are rejected.
Web/EMS: Challenge Caching
Mode
[SIPChallengeCachingMode]
Determines the mode for Challenge Caching, which reduces
the number of SIP messages transmitted through the network.
The first request to the Proxy is sent without authorization. The
Proxy sends a 401/407 response with a challenge. This
response is saved for further uses. A new request is re-sent
with the appropriate credentials. Subsequent requests to the
Proxy are automatically sent with credentials (calculated from
the saved challenge). If the Proxy doesn't accept the new
request and sends another challenge, the old challenge is
replaced with the new one.
[0] None = Challenges are not cached. Every new request
is sent without preliminary authorization. If the request is
challenged, a new request with authorization data is sent.
(default)
[1] INVITE Only = Challenges issued for INVITE requests
are cached. This prevents a mix of REGISTER and INVITE
authorizations.
[2] Full = Caches all challenges from the proxies.
Note: Challenge Caching is used with all proxies and not only
with the active one.
Web: Proxy IP Table
EMS: Proxy IP
[ProxyIP]
This ini file table parameter configures the Proxy Set table with
Proxy Set IDs, each with up to five Proxy server IP addresses
(or fully qualified domain name/FQDN). Each Proxy Set can be
defined with a transport type (UDP, TCP, or TLS). The format
of this parameter is as follows:
[ProxyIP]
FORMAT ProxyIp_Index = ProxyIp_IpAddress,
ProxyIp_TransportType, ProxyIp_ProxySetId;
[\ProxyIP]
For example:
ProxyIp 0 = 10.33.37.77, -1, 0;
ProxyIp 1 = 10.8.8.10, 0, 2;
ProxyIp 2 = 10.5.6.7, -1, 1;
Notes:
This parameter can include up to 32 indices (0-31).
To assign various attributes (such as Proxy Load Balancing)
per Proxy Set ID, use the parameter ProxySet.
For configuring the Proxy Set ID table using the Web
interface and for a detailed description of the parameters of
this ini file table, see ''Configuring Proxy Sets Table'' on
page 106.
For an explanation on using ini file table parameters, see
''Configuring ini File Table Parameters'' on page 194.
To Next Page
Loading...
