AUTOFLAME Mk8 MM User Manual

10 Water Level Control
Mk8 MM Manual Page | 192
10.9.6 Setting Control Point Level
Figure 10.9.8.i Commission Control Point Level
After storing or updating the 1
st
low level, press to increase the water level to the 1
st
low level.
Once the water has risen to the required control point level, turn the pump off and close the valve. Let the
readings settle and press .
If required, the control point level can be updated by then adjusting the water level and pressing
once the position has been stored.

AUTOFLAME Mk8 MM Specifications

General

Brand	AUTOFLAME
Model	Mk8 MM
Category	Controller
Language	English