AUTOFLAME Mk8 MM - Parts Required for Draught Control

13 Draught Control
Mk8 MM Manual Page | 241
13.1.1 Parts Required for Draught Control
Depending on the setup, Draught Control may require the following parts:
• Air Pressure Sensor – please see Autoflame Sensors Guide.
A siphon loop must be fitted on the flue for air sensor.
• Positioning Servomotor, this may also require a mounting kit if used with a third-party damper –
please see Autoflame Valves and Servomotors Guide.
• Draught Damper – Available upon request with the servo mounting fitted as standard, please contact
Autoflame for sizes and availability.
Figure 13.1.1 Draught Control installation and wiring schematic