3 Commissioning Procedure
Mk8 MM Manual Page | 83
3.4.9 Set FGR Position
If FGR Start has been enabled in options 48, 49 or 50 on a system which has not been commissioned, the
message ‘Set FGR Position’ will display after entering the light-off START position. If Golden Start has been
enabled in option 29, this message will appear after entering the GOLDEN START position.
Figure 3.4.9.i Set FGR Position
Press to enter the FGR START position. After entering the FGR START position, proceed to the
commissioning steps in section 3.4.10.
Enabling FGR Start on a Commissioned System
If the system has already been commissioned without FGR Start enabled, go into Commission mode and set
option 48, 49 or 50 to enable FGR Start. The forced commission message will appear as ‘FGR optioned but
not commissioned.’
Press on the home screen and once the system goes through its internal relay tests, the
message ‘Select Commissioning’ will appear.
Press to go through the commissioning process and enter the CLOSED, OPEN, light-off
START and GOLDEN START (if enabled) positions. After the entering the light-off START or GOLDEN
START (if enabled) position, the message ‘Set FGR Position’ will appear; press to enter the
stored FGR START position and continue with the full commissioning procedure in section 3.4.10.
Alternatively, to just add the FGR Start position and not go through the whole commissioning procedure,
press on the home screen, and once the system has gone through its internal relay tests the
To Next Page
Loading...
