AUTOFLAME Mk8 MM User Manual

3 Commissioning Procedure
Mk8 MM Manual Page | 97
3.7 Single Point Change
Figure 3.7.i Single Point Change
Single Point Change can only be accessed when the burner is firing and in Run mode. Press in
the system configuration screen and enter the password to access Single Point Change mode.
Select the point to be edited or added trim to by pressing or to go up and down the
fuel curve, then press .
The Status screen will display the message ‘Select change to make’.

AUTOFLAME Mk8 MM Specifications

General

Brand	AUTOFLAME
Model	Mk8 MM
Category	Controller
Language	English