AUTOFLAME Mk8 MM User Manual

3 Commissioning Procedure
Mk8 MM Manual Page | 79
Figure 3.4.6.ii Commissioning with Trim
After you press to save those servomotor positions, the EGA will carry out its fuel rich and air
rich trim.
Once these trim values have been saved, the system will continue with the commissioning process.
Note: If the MM has not been enabled for trim during commissioning, this can be added later by setting
option12 for trim, and going into Single Point Change to add trim to each point, see section 3.7.

AUTOFLAME Mk8 MM Specifications

General

Brand	AUTOFLAME
Model	Mk8 MM
Category	Controller
Language	English