Automatic Systems SmartLane - Page 4

6.3. Mechanical transmission of motion .................................................................... 45
6.4. Mobile obstacle ..................................................................................... 46
6.5. Fixed obstacle ...................................................................................... 46
7. Operation ...............................................................................47
7.1. Powered Operation Mode ............................................................................. 47
7.2. Obstacles idle status ................................................................................ 47
7.3. Operating Mode by Direction of Passage ................................................................ 47
7.4. Passage Authorizations .............................................................................. 47
7.5. Evacuation mode .................................................................................... 48
7.6. Power Failure ....................................................................................... 48
7.7. Technical fault ...................................................................................... 48
7.8. Obstacle lock ....................................................................................... 48
7.9. Analog inductive position sensor ...................................................................... 48
7.10. Safety devices ...................................................................................... 48
7.11. Proper use .......................................................................................... 49
7.12. Breaches .......................................................................................... 49
7.12.1. “When idle” Breach .....................................................................................................50
7.12.2. “Wrong way” breach ....................................................................................................50
7.12.3. “Tailgating after authorized passage” breach. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50
7.12.4. “Tailgating before authorized passage” breach ............................................................................51
7.12.5. “Grouping before authorized passage” breach .............................................................................51
7.12.6. “Security zone” breach .................................................................................................51
7.12.7. “Stolen ticket” breach ..................................................................................................52
7.12.8. "Obstacle prevented from closing” breach ................................................................................52
7.12.9. "Obstacle prevented from opening” breach ................................................................................52
8. Maintenance ............................................................................ 53
8.1. Recommended tools ................................................................................. 53
8.2. Recommended tightening torque ...................................................................... 53
8.3. Switching the equipment on/off ...................................................................... 54
8.3.1. Removing the side panel on the RIGHT - DIRECTION A ........................................................................54
8.3.2. Power off .............................................................................................................54
8.3.3. Power on ..............................................................................................................55
8.4. Adjusting the obstacle closing point ................................................................... 55
8.5. Locking the mobile obstacle in the open/closed position ................................................ 56
8.6. Fitting a panel (side or end) ........................................................................... 57
8.7. Removing the fixed obstacle .......................................................................... 58
8.8. Installing a fixed obstacle (after possible replacement) .................................................. 59
8.9. Adjusting the fixed obstacle .......................................................................... 60
8.10. Removal / installation of the mobile obstacle ........................................................... 62
8.10.1. Increasing the Visibility of Mobile Obstacles ...............................................................................64
8.11. Replacing the protective seal on the mobile obstacle .................................................... 65
8.12. Removal / installation of the closing flap ............................................................... 66
8.13. Removing / installing the closing flap .................................................................. 67
8.14. Adjusting the position of the closing flap guide ......................................................... 68
8.15. Removing the cover plate ............................................................................. 69
8.15.1. Removing a short plate (Units with high glass obstacles) ...................................................................69
8.15.2. Removing a long plate (Units with low glass obstacles) .....................................................................70
8.16. Installing the cover plate ............................................................................. 71
8.17. Removing a Housing extension ........................................................................ 72
2
SmartLane