Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Connectivity and Access to DEFINITY ONE or IP600
2-5Creating physical connections
2
Install the ethernet card
1. Ensure the laptop power is off.
2. Insert a PCMCIA ethernet card into the laptop.
NOTE:
The ethernet card can be any brand or model desired. A card with
100 mbps capability provides faster response.
3. Using the RJ45 crossover cable, an RJ45 coupler (BRIA4P) and a D8W
cable, connect the RJ45 jack in the TN2314 circuit pack to the Ethernet
card in the laptop. See Figure 2-1 on page 2-3.
4. Power up the laptop and start Windows 2000 or Windows 95.
Configure the laptop PCMCIA ethernet client
1. In Windows Explorer, right-click on Network Neighborhood folder to set
up the network PCMCIA interface to communicate to the DEFINITY ONE
or IP600 system.
NOTE:
The following details are for a specific version of Windows 95. Other
system versions might have dialog boxes that are slightly different.
NOTE:
For Windows 2000, use the Terminal Services Client to connect to
the DEFINITY ONE or IP600. For more information, see ‘‘Logging on
to Definity One or IP600 Desktop using Windows 2000’’ on page
2-11.
To Next Page
Loading...
