Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Miscellaneous Procedures
C-7Installing INTUITY languages other than English
C
For Windows
TM
2000, there have been some changes:
1. Right click on My Network Places, and select Properties.
This opens the
Network and Dial-up Connection
window.
2. Right click on the Local Area Connection, and select Properties.
3. In the
Connect Using
window, select the General tab.
4. Left click on Internet Protocol (TCP/IP) in the lower portion of the window.
5. Left click on Properties, which is now selectable.
6. If there is an IP address in the next window, write it and any other
information down. these will be needed later.
NOTE:
If Use the following IP address does not have a dot in it, left click it.
7. Change the
IP Address
to 192.11.13.5 and the
Subnet Mask
to
255.255.255.252.
NOTE:
If there is anything in the DNS, the system needs to be rebooted for
the changes to take effect.
8. Click OK.
9. Close the windows and reboot the system, if needed.
10. Connect the cable between the laptop and the TN2314 NIC card.
!
CAUTION:
When using Terminal Server
TM
, because of the size of the laptop
display, use the scroll bar on the right side of the display to go to the
bottom of the desktop screen. That is where the Start button for the
desktop is found. Otherwise, the Start button on the Taskbar may be
that of the laptop. The technician can also right click on the laptop
Taskbar, select Properties, and check the Auto Hide box. This will
cause the Taskbar to be hidden until the cursor is moved to the very
bottom of the display.
To Next Page
Loading...
