Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10
555-233-109
Issue 6
December 2001
Install and Cable the Cabinet
1-59Install the DEFINITY ONE system cabinet
1
Install cabinet — wall-mount
Figure 1-26. Left panel used as mounting template
To mount a cabinet on a wall:
1. Place the template on the wall with the top surface level.
2. Mark 2 1/8-inch (0.3-cm) pilot holes in the mounting hole locations.
3. Remove the template from the wall.
4. Drill the 2 pilot holes.
5. Thread 2 #12 x 1-inch shoulder screws partially into the holes.
FLOOR
indmpnl3 KLC 110397
5" (12.7 cm)
12"
(30.5 cm)
54"
(137 cm)
To Next Page
Loading...
