Avaya JEM24 Installing

Parameter name Default
value
Description
• 2: EAPOL multicast pass-through
disabled.
DOT1XEAPS MD5 Specifies the authentication method
to be used by 802.1X.
Valid values are MD5, and TLS.
DOT1XSTAT 0 Specifies the 802.1X supplicant
operating mode.
Value Operation:
• 0: Supplicant disabled.
• 1: Supplicant enabled, but
responds only to received unicast
EAPOL messages.
• 2: Supplicant enabled; responds
to received unicast and multicast
EAPOL messages.
DSCPAUD 46 Specifies the layer 3 Differentiated
Services (DiffServ) Code Point for
audio frames generated by the
phone.
Valid values are from 0 to 63.
This parameter can also be set
through the LLDP, which overwrites
any value set in this file.
DSCPAUD_FL 43 Specifies the DSCP value for flash
precedence or priority level voice
call.
Valid values are from 0 to 63.
DSCPAUD_FO 41 Specifies the DSCP value for flash
Override precedence or priority
level voice call.
Valid values are from 0 to 63.
DSCPAUD_IM 45 Specifies the DSCP value for
immediate precedence or priority
level voice call.
Valid values are from 0 to 63.
DSCPAUD_PR 47 Specifies the DSCP value for
priority precedence or priority level
voice call.
Valid values are from 0 to 63.
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 209
Comments on this document? infodev@avaya.com

Avaya JEM24 Specifications

General

Brand	Avaya
Model	JEM24
Category	IP Phone
Language	English