Avaya JEM24 Installing

Name Description
The options are:
• Disable
• Enable (default)
Send DTMF Specifies whether the phone sends DTMF tones in-band as regular audio,
or out-of-band using RFC 2833 procedures.
The options are:
• In-band
• Out-of-band (default)
OPUS Payload Dynamically specifies the RTP payload type to be used for OPUS codec.
The parameter is used when the media request is sent to the far-end in an
INVITE or 200 OK when INVITE with no Session Description Protocol
(SDP) is received.
The valid value is an integer from 96 to 127. The default value is 116.
G.726 Payload Specifies the RTP payload type to be used for the G.726 codec.
The valid value is an integer from 96 to 127. The default value is 110.
DTMF Payload Specifies the RTP payload type to be used for RFC 2833 signaling.
The valid value is an integer from 96 to 127. The default value is 120.
RTP
Play Tone till RTP Specifies whether the locally generated ringback tone stops when SDP is
received for an early media session, or whether it continues until RTP is
actually received from the far-end party.
The options are:
• Yes (default)
• No
Symmetric RTP Specifies whether the phone must receive RTP if the UDP source port
number is not same as the UDP destination port number.
The options are:
• Disable
• Enable (default)
RTCP_XR Specifies whether VoIP Metrics Report Block as defined in RTP Control
Protocol Extended Reports (RTCP XR) (RFC 3611) is sent as part of the
RTCP packets to a remote peer or an RTCP monitoring server.
The options are:
• Yes
• No (default)
SRTP
Table continues…
Configuring the phone using web interface
December 2018 Installing and Administering Avaya J100 Series IP Phones 62
Comments on this document? infodev@avaya.com

Avaya JEM24 Specifications

General

Brand	Avaya
Model	JEM24
Category	IP Phone
Language	English