CONFIGURA TION 191
CONFIGURA TION 2
SOFTW ARE TERMIN ALS 3
SOFTW ARE TERMIN ALS 3
308)INTERN AL RUN IP
SOFTW ARE TERMIN ALS 3
305)A NDED RUN
SOFTW ARE TERMIN ALS 3
306)A NDED J OG
SOFTW ARE TERMIN ALS 3
307)A NDED ST ART
13.9 CONFIGURATION / SOFTWARE TERMINALS
PIN numbers used 305 to 308.
The 3 drive control functions are ANDED with
their respective hardware equivalent input
terminal and the resulting output controls the
drive. This allo ws the local terminal function to
be over-ridden by a remote command, OR a
remote command to be over-ridden by a local
terminal.
13.9.1 SO FTW ARE TERMIN ALS / Anded run PIN 305
305)A NDED RUN is normally used by a serial link
to control the drive. The local hardware terminal in
the LOW position will defeat the serial link.
The serial link in the OFF position. will defeat the
local hardware terminal.
Note. If the RUN terminal has been used as a
general digital input, then 308)INTERNAL RUN IP
must be set HIGH for the drive to run.
13.9.2 SO FTW ARE TERMIN ALS / Anded jog PIN 306
306)A NDED J OG is normally used by a
serial link to control the drive. The local
hard ware terminal in the LO W position
will defeat the serial link.
The serial link in the OFF position will
defeat the local hardware terminal.
From J OG T 32
From ANDED
JO G PIN 30 6
HIGH or LOW
To internal
system
From RUN T31
From ANDED
RUN PIN 30 5
HIGH or LOW
To internal
system
PIN 308
Internal
RUN
SOFTW ARE TERMIN ALS 3
305)A NDED RUN
305)A NDED RUN
HIGH
PARA METER RA NGE DEFAULT PIN
ANDED RUN HIGH or LO W HIGH 305
Sets a logic input to an internal
AND gate to control RUN.
SOFTW ARE TERMIN ALS 3
306)A NDED J OG
306)A NDED J OG
HIGH
PARA METER RA NGE DEFAULT PIN
ANDED J OG HIGH or LO W HIGH 306
Sets a logic input to an internal
AND gate to control JOG
To Next Page
Loading...