EasyManua.ls Logo

Best GENIUS Compact - Preface E: GENIUS Compact optical sorter Warranty & Responsibility; Warranty Limitations; General Conditions

Best GENIUS Compact
238 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety prefaces
X
Operators & Maintenance Manual GENIUS Compact Version UK 0.1 © BESTnv
BESTnv Industrial Research BV, Marinus van Meelweg 20, 5657 EN, EINDHOVEN, THE NETHERLANDS
General tel. +31 (40) 292 2622 - Service tel. +31 (40) 292 2620 - Fax. +31 (40) 292 2633 - Email: service.BESTnv@bestnv.com
Preface E:
GENIUS Compact optical sorter Warranty &
Responsibility
If not otherwise agreed in writing, the following rules apply to claim warranty :
The warranty is limited to the warranty period mentioned in the contract.
Failures caused by lightning, fl oods, storm or other environmental events are excluded from warranty.
Failures during warranty period have to be reported to the Vendor within 24 hours.
• During warranty period the defective parts must be returned to the Vendor within 30 days after the report
of the problem in order to claim warranty.
Warranty excludes the loss of production caused by the failure of the machine.
Failures resulting from an error made by the operator are excluded from warranty.
Damages caused by the Purchaser while moving the machine are excluded from warranty.
No changes to the electrical wiring can be done without written permission of the Vendor.
No mechanical adaptations can be done without written permission of the Vendor.
No electronic adaptations can be done without written permission of the Vendor.
All cleaning detergents have to be approved in writing by the Vendor.
The machine cannot be installed in corrosive environments.
User is at all times responsible for the quality of water, compressed air and electricity.
Components damaged by over-voltage are not covered by warranty.
Environmental temperature has to be within the limits described in the technical annex attached to the
contract or if different it must be specifi ed at the moment of the order.
No welding may be done on or near the machine.
If something has to be mounted on the machine, clamps have to be used instead of fi xing holes or
welding.
To claim warranty the maintenance program, as described in paragraph 8.2 Essential maintenance
tasks, under Weekly, Monthly, Yearly and Preventive Maintenance, must be applied to the GENIUS
Compact optical sorter.
BESTnv cannot be held responsible for unsafe situations, accidents, failures or damages which are
caused by disregard for warnings and prescriptions as indicated in this manual.
Laser box (if present) may not be opened without explicit written permission of the Vendor.
• The GENIUS Compact can only be used for the purpose it has been sold for, as described in the
contract.
The Vendor cannot be held responsible for failures caused by the use of other spare parts than those
approved by the Vendor.
• The Vendor cannot be held responsible for safety hazards caused by the Purchaser as a result of removing
or adapting the safety circuits and/or components.
A distinction is being made between normal daily use (operator), normal maintenance and service. This
distinction was made because of the different requirements to be met by service personnel, maintenance
personnel or operators.

Table of Contents