Best GENIUS Compact - II. Unpacking and placing of GENIUS Compact sorter (continued); 2.5.7. Product streams to and away from the GENIUS Compact sorter

2/23
Chapter 2: Pre-installation Guide:
Unpacking & placing of GENIUS Compact optical sorter
Operators & Maintenance Manual GENIUS Compact Version UK 0.1 ©
BESTnv
Pulsarr Industrial Research BV, Marinus van Meelweg 20, 5657 EN, EINDHOVEN, THE NETHERLANDS
General tel. +31 (40) 292 2622 - Service tel. +31 (40) 292 2620 - Fax. +31 (40) 292 2633 - Email: service.pulsarr@bestnv.com
Picture 2.5.31: Bad:
product to one side of infeed area
Picture 2.5.30: Good:
product in middle of infeed area
2.5.7. Product streams to and away from the GENIUS Compact sorter
The input of the infeed shaker
The Purchaser is responsible for feeding the infeed shaker of the sorter using a belt, an elevator, or any
other equipment. This equipment must be ready and installed before the arrival of BESTnv’s personnel
for the start-up. Feeding must be done in the middle of the product infeed area, and must be immediately
dispersed over minimum 80% of the width of the shaker, in order to accomplish maximum dispersal of
the product on the belt and maximum effi ciency of the sorter unit (see pictures 2.5.27 and 2.5.28).