Best GENIUS Compact - V. Routine Operational Procedures (continued); 5.7. Setting a New Product File

Chapter 5: Routine Operational Procedures
5/15
Operators & Maintenance Manual GENIUS Compact Version UK 0.1 © BESTnv
BESTnv Industrial Research BV, Marinus van Meelweg 20, 5657 EN, EINDHOVEN, THE NETHERLANDS
General tel. +31 (40) 292 2622 - Service tel. +31 (40) 292 2620 - Fax. +31 (40) 292 2633 - Email: service.BESTnv@bestnv.com
5.7. Setting a New Product File
Preparation:
1.- Switch on the sorter as described in the start procedures, but do not switch on the infeed shaker,
belt or return system. Make sure all is clean and ready for sorting.
2.- Before adjusting any optical settings or starting the product fl ow to the sorter installation, fi rst take
new Normalizations for all devices (all cameras and/or lasers), see subchapter 5.4.
Attention: - Always take into account the warm-up time for the lights and optics, (+/-30
min. after a longer stop), before taking normalizations.
- Make sure the Product is available before starting Product Setup.
- If a Product File exists for a product that is similar to the product you want
to sort, it is always advisable to load that Product File before performing this
procedure (See Subchapter 5.6. Saving and Loading Product Files.)
- When starting from a preexisting Product File, it is usually possible to skip
Part 1 of this Product Setup Procedure. When in doubt, please check Part 1, to
see whether the settings correspond with you product.