To upload a firmware
Click Browse and select the firmware file and load into the memory.1.
Click Upload.2.
Result: The upload proceeds and the firmware upload process is displayed in the Status
section.
Device Manager checks if the selected device matches the firmware.3.
The firmware update begins.4.
When firmware update is complete, a checksum is performed to verify the upload.5.
When checksum is complete, the device reboots.6.
Status: Displays the current state of the firmware in the selected device.
Not Ready (no file loaded)
Ready (file loaded/previous flash complete)
Preparing...(jumping to boot loader)
Flashing...(Actually flashing the device)
Verifying...(checksum)
Finishing up...(jumping to main)
Device Settings for a Router
To open device settings widget for a Router
In the Main Panel, click on the Router that you want to select.1.
Result: The Device Settings widget displays the settings of the selected Router.
Selected Device: Displays Router.
Serial Number: The serial number of the selected Router.
Product Info: The additional information or name that was set to identify the selected Router.
To change the settings in device settings for a Router
Click on the Wireless Channel drop-down arrow and select the Wireless Channel number from the1.
drop-down list if you want to change the previously assigned Wireless Channel.
Click Apply.2.
On the Subnet scroll box, click the arrows and select the Subnet (or type a new number) that3.
devices on the same Wireless Channel will use to communicate.
Click Apply.4.
In the Loaded Firmware section, a device firmware can be located, selected and uploaded into5.
the selected Router(s).
To upload a firmware
Click Browse and select the firmware file and load into the memory.1.
Click Upload.2.
Result: The upload proceeds and the firmware upload process is displayed in the Status
section.
Device Manager checks if the selected device matches the firmware.3.
The firmware update is complete, a checksum is performed to verify the upload.4.
When checksum is complete, the device reboots.5.
Status: Displays the current state of the firmware in the selected device.
Not Ready (no file loaded)
Ready (file loaded/previous flash complete)
To Next Page
Loading...