number) that devices on the same Wireless Channel will use to communicate.
Click Apply.9.
Result: The Subnet is changed and the Current Preset displays Custom.
On the LED Brightness (ms) scroll box, click the arrows and select the length of exposure (in10.
milliseconds) (or type in a number, from 1-8) to increase or decrease the brightness of the LED.
Click Apply.11.
Result: The LED Brightness is changed and the Current Preset displays Custom.
Note: The increase in the level of LED Brightness will decrease the battery life of the Beacon
but may result in the LED being seen at farther distances. (Default = 3ms)
In the Loaded Firmware section, a device firmware can be located, selected and uploaded into12.
the selected Beacon(s).
To upload a firmware
Click Browse and select the firmware file and load into memory.1.
Click Upload.2.
Result: The upload proceeds and the firmware upload process is displayed in the Status
section.
Device Manager checks if the selected device matches the firmware.3.
The firmware update begins.4.
When firmware update is complete, a checksum is performed to verify the upload.5.
When checksum is complete, the device reboots.6.
Status: Displays the current state of the firmware in the selected device.
Not Ready (no file loaded)
Ready (file loaded/previous flash complete)
Preparing...(jumping to boot loader)
Flashing...(Actually flashing the device)
Verifying...(checksum)
Finishing up...(jumping to main)
Device Settings for a TimeKeeper
To open device settings widget for a TimeKeeper
In the Main Panel, click on the TimeKeeper that you want to select.1.
Result: The Device Settings widget displays the settings of the selected TimeKeeper.
Selected Device: Displays TimeKeeper.
Serial Number: The serial number of the selected TimeKeeper.
Product Info: The additional information or name that was set to identify the selected
TimeKeeper.
To change the settings in device settings for a TimeKeeper
Click on the Wireless Channel drop-down arrow and select the Wireless Channel number from the1.
drop-down list if you want to change the previously assigned Wireless Channel.
Click Apply.2.
On the Subnet scroll box, click the arrows and select the Subnet number (or type a new number)3.
that devices on the same Wireless Channel will use to communicate.
Click Apply.4.
In the Loaded Firmware section, a device firmware can be located, selected and uploaded into5.
the selected TimeKeeper(s).
To Next Page
Loading...