02-22
CFMOTO
Torque Table - Engine Components
Item Qty Type (mm) Torque (N·m) Remark
Bolt M14×1.5 4 M14×1.5 40
Magnetic drain bolt M14×1.5 1 M14×1.5 25
Screw plug 1 ZM14 20
Apply thread
locker
Drain bolt M12×1.5 1 M12×1.5 20
Flange bolt M8×12.5 (MAG side
crankcase)
1 M8×12.5 20
Restriction plug 1 R21/8 20
Apply thread
locker
Screw R21/8 (Oil line in PTO side
crankcase)
1 R21/8 20
Apply thread
locker
Screw M4×10 (Crankshaft washer
lock nut)
2 M4×1 3
Apply thread
locker
Nut M6 (PTO side crankcase) 4 M6 10
Bolt (MAG side cover) 2 M5×10 6
Apply thread
locker
Bolt M12×1.25×35 (Magneto rotor) 1 M12×1.25 70
Adjusting nut, valve clearance 8 M6 12
Bolt, timing chain 2 M8 30
Apply thread
locker
Bolt plug, tensioner 2 M6×5 5
Bolt, cylinder 8 M10 20,60
2-step torque
procedure
Pushing nut M8 (air exhaust port) 4 M8 13
Spark Plug 2 M12×1.25 20
Stud M8×42 (air exhaust port) 4 M8×42 25
Apply thread
locker
Screw plug M12×1.5 (first cylinder
head)
1 M12×1.5 20
Self-tapping screw ST4.8×13
(Thermostat cover)
2 ST4.8×13 5
Lock pin, tensioner 2 M6×16 10
Apply thread
locker
Bolt M8×25, air inlet pipe 4 M8×25 20
Bolt, connecting rod 4 M9×1 10, 20, 50
3-step torque
procedure
Nut, drive pulley 1 M20×1.5 180 Left-hand thread
Bolt, drive pulley (CVT drive pulley) 1 M12×1.5 60 Left-hand thread
Nut, main drive shaft (CVT driven
pulley)
1 M22×1.5 150
Lock nut, bevel gear 1 M27×1.5 145
Bolt M8×28 (Drive bevel bearing seat) 4 M8×28 30
Screw M8×25 (Drive bevel bearing
pressing plate)
4 M8×25 15
Bearing retainer, front output shaft
bearing retainer
1 M55×1.5 80
Apply thread
locker
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page