CFMOTO
08-4
Inspection
Brake uid level should be between upper
line and lower line.
Add brake uid if the level is below or near
the lower line.
Reduce brake uid if the level is above or
near the upper line.
NOTE: Brake fluid will reduce the
braking effect after using for a long
time. Replace the brake uid according
to the maintenance schedule.
NOTE:
1. Do not mix dirt and water with brake
uid when adding.
2. Use CFMOTO recommended brake
uid in case of chemical changes.
3. Contact with brake uid may irritate
the skin.
4. Do not let the brake fluid contact
painted parts. The brake fluid will
corrode the paint.
5. Flush with water if brake uid spills.
6. Do not leave the brake uid reservoir
cap open for a long time.
Brake Fluid Replacement and Brake
System Bleeding
Please use CFMOTO recommended brake
uid for replacement.
Brake uid type: DOT4
If equipped with bleeding device, follow the
user manual to operate.
If not, bleed the brake system according to
the following procedures:
Remove anti-dust cap from the bleeder
Connect a hose at the brake caliper bleed
screw with the other side into a clean
container. Make sure the hose is fastened
on bleed port
1
.
Press brake pedal slowly and hold it.
Loosen bleed screw, tighten it immediately
and allow the brake pedal to return.
NOTE
: Keep the uid level more than a
half from the upper line in the reservoir
during bleeding.
NOTE
: Do not release brake pedal before
tightening bleed screw. Otherwise, there
will be air inside the master cylinder.
Upper
Lower
1
080401
080402
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page