Chery Automobile Co., Ltd.
28 - STEERING COLUMN
28–12
28
Installation
1. Adjust the spiral cable to correct position.
HINT:
Fully turn the spiral cable inner circle clockwise when
realigning the center, and then turn it counterclockwise to
align with ►◄ while yellow ball (arrow) occurs in the
clear vertical window. Failure to follow these instructions
may affect normal function of airbag system and cause
injury to driver.
2. Pass the airbag connector, horn connector through the hole of steering wheel assembly, and connect the
steering wheel quick button connector. Then align the matchmarks on steering wheel assembly and
steering column assembly to install the steering wheel assembly.
3. Other installation procedures are in the reverse order of removal.
ï‚· Check that front wheels are in the straight-ahead position before installing steering wheel assembly.
ON
OFF
REAR
INT
PULL
MIST
OFF
INT
LO
HI
OFF
PBT
RT21280070
ï‚· Tighten steering wheel assembly fixing nut to the specified torque.
ï‚· Install each connector in place.
ï‚· After repairing, check that airbag system operates normally.
To Next Page
Loading...
Need help?
General
