Chery Automobile Co., Ltd.
17 - QR525MHE TRANSMISSION
17–16
17
Differential Oil Seal
Removal
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Raise the vehicle with a lifter.
2. Drain transmission oil.
a. Remove the retaining plug and washer.
b. Remove the drain plug and washer, and drain the transmission oil.
c. Install the new washer and drain plug.
(Tightening torque: 40 ± 6 N·m)
3. Remove the front left wheel (See page 24-9).
4. Remove the left drive shaft (See page 20-5).
5. Pull out the oil seal with a puller.
Installation
1. Apply an appropriate amount of transmission oil to the lip of new oil seal.
2. Using a special tool and a hammer, tap in the oil seal.
Make sure to wear safety equipment to prevent accidents.
Check if safety lock of lifter is locked when performing vehicle lift repair and inspection.
Drained transmission oil should be collected with a recovering tool.