Chery T21 2014 User Manual

Chery Automobile Co., Ltd.
32 - SUPPLEMENTAL RESTRAINT SYSTEM
32–65
32
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the driver airbag.
a. Position the front wheels straight ahead.
b. Using a flat tip screwdriver wrapped with protective
tape, push the driver airbag snap springs (arrow) from
the service hole.
c. Disengage the driver airbag from the steering wheel, and support the driver airbag smoothly by hand.
d. Disconnect the driver airbag wire harness connector
(1) and horn wire harness connector (2).
CAUTION
 Handle the airbag and airbag control module assembly carefully, and never tap or strike them fiercely.
 Removal, inspection and installation of airbag system must meet the relevant requirements and
specifications, and never perform operation casually.
 The removed airbag should be kept properly with the face up. Store the airbag in a place with enough
spare space to prevent accidental airbag deployment.
WARNING
 Wait at least 90 seconds after disconnecting negative battery cable to disable supplemental restraint
system.
RT21320040
RT21320050
1
2
CAUTION
 DO NOT pull the airbag wire harness when removing driver airbag.

Chery T21 2014 Specifications

General

Brand	Chery
Model	T21 2014
Category	Automobile
Language	English