Chery T21 2014 - Front Bumper Assembly; Removal

Chery Automobile Co., Ltd.
48 - EXTERIOR
48–11
48
Front Bumper Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the radiator grille assembly (See page 48-8).
4. Remove the front bumper assembly.
a. Raise the vehicle with a lifter, and remove 5 fixing
screws (arrow) between front bumper assembly and
front wheel house protector assembly (take left side
as an example).

(Tightening torque: 3 ± 1 N·m)
b. Remove 3 plastic clips (arrow) from the lower part of
front bumper assembly.
c. Remove 2 fixing screws (1) from the lower part of front
bumper assembly.

(Tightening torque: 3 ± 1 N·m)
d. Remove 2 fixing bolts (2) from the lower part of front
bumper assembly.

(Tightening torque: 10 ± 1 N·m)
e. Lower the vehicle to a proper position, and remove 6
fixing bolts (arrow) from the upper part of front bumper
assembly.

(Tightening torque: 10 ± 1 N·m)
CAUTION
 Be sure to wear safety equipment to prevent accidents when removing front bumper assembly.
 Appropriate force should be applied when removing front bumper assembly. Be careful not to operate
roughly.
 Try to prevent body paint surface from being scratched when removing front bumper assembly.
RT21480211
1
1
2
RT21480050
RT21480060