Schedule Power Save for Cisco IP Phone
To conserve power and ensure the longevity of the phone screen display, you can set the display to turn off
when it is not needed.
You can configure settings in Cisco Unified Communications Manager Administration to turn off the display
at a designated time on some days and all day on other days. For example, you may choose to turn off the
display after business hours on weekdays and all day on Saturdays and Sundays.
You can take any of these actions to turn on the display any time it is off:
•
Press any button on the phone.
The phone takes the action designated by that button in addition to turning on the display.
•
Lift the handset.
When you turn the display on, it remains on until the phone has remained idle for a designated length of time,
then it turns off automatically.
For more information, see Product Specific Configuration, on page 138
Procedure
Step 1
In Cisco Unified Communications Manager Administration, select Device > Phone.
Step 2
Locate the phone that you need to set up.
Step 3
Navigate to the Product Specific Configuration area and set the following fields:
•
Days Display Not Active
•
Display On Time
•
Display On Duration
•
Display Idle Timeout
Table 24: PowerSave Configuration Fields
DescriptionField
Days that the display does not turn on automatically at the time specified in the
Display On Time field.
Choose the day or days from the drop-down list. To choose more than one day,
Ctrl-click each day that you want.
Days Display Not Active
Time each day that the display turns on automatically (except on the days
specified in the Days Display Not Active field).
Enter the time in this field in 24-hour format, where 0:00 is midnight.
For example, to automatically turn the display on at 07:00 a.m., (0700), enter
07:00. To turn the display on at 02:00 p.m. (1400), enter 14:00.
If this field is blank, the display will automatically turn on at 0:00.
Display On Time
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
156
Phone Feature Configuration
To Next Page
Loading...
Need help?
General
