Cisco 8811

Sample CallInfo Output
The following XML code is an example of the output from the CallInfo command.
<?xml version="1.0" encoding="UTF-8"?>
<CiscoIPPhoneCallLineInfo>
<Prompt/>
<Notify/>
<Status/>
<LineDirNum>1030</LineDirNum>
<LineState>CONNECTED</LineState>
<CiscoIPPhoneCallInfo>
<CallState>CONNECTED</CallState>
<CallType>INBOUND</CallType>
<CallingPartyName/>
<CallingPartyDirNum>9700</CallingPartyDirNum>
<CalledPartyName/>
<CalledPartyDirNum>1030</CalledPartyDirNum>
<HuntPilotName/>
<CallReference>30303060</CallReference>
<CallDuration>12835</CallDuration>
<CallStatus>null</CallStatus>
<CallSecurity>UNAUTHENTICATED</CallSecurity>
<CallPrecedence>ROUTINE</CallPrecedence>
<FeatureList/>
</CiscoIPPhoneCallInfo>
<VisibleFeatureList>
<Feature Position="1" Enabled="true" Label="End Call"/>
<Feature Position="2" Enabled="true" Label="Show Detail"/>
</VisibleFeatureList>
</CiscoIPPhoneCallLineInfo>
Sample LineInfo Output
The following XML code is an example of the output from the LineInfo command.
<CiscoIPPhoneLineInfo>
<Prompt/>
<Notify/>
<Status>null</Status>
<CiscoIPPhoneLines>
<LineType>9</LineType>
<lineDirNum>1028</lineDirNum>
<MessageWaiting>NO</MessageWaiting>
<RingerName>Chirp1</RingerName>
<LineLabel/>
<LineIconState>ONHOOK</LineIconState>
</CiscoIPPhoneLines>
<CiscoIPPhoneLines>
<LineType>9</LineType>
<lineDirNum>1029</lineDirNum>
<MessageWaiting>NO</MessageWaiting> <RingerName>Chirp1</RingerName>
<LineLabel/>
<LineIconState>ONHOOK</LineIconState>
</CiscoIPPhoneLines>
<CiscoIPPhoneLines>
<LineType>9</LineType>
<lineDirNum>1030</lineDirNum>
<MessageWaiting>NO</MessageWaiting>
<RingerName>Chirp1</RingerName>
<LineLabel/>
<LineIconState>CONNECTED</LineIconState>
</CiscoIPPhoneLines>
<CiscoIPPhoneLines>
<LineType>2</LineType>
<lineDirNum>9700</lineDirNum>
<MessageWaiting>NO</MessageWaiting>
<LineLabel>SD9700</LineLabel>
<LineIconState>ON</LineIconState>
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
235
Request Information from the Phone in XML