DescriptionItem
Indicates if the Federal Information Processing Standard (FIPS) Mode is enabled.FIPS mode enabled
Network Setup
The Network setup area on a phone web page displays network setup information and information about other
phone settings. The following table describes these items.
You can view and set many of these items from the Network Setup menu on the Cisco IP Phone.
Some of the items in the following table do not apply to all phone models.Note
To display the Network Setup area, access the web page for the phone as described in Access Web Page for
Phone, on page 217, and then click the Network setup hyperlink.
Table 41: Network Setup Area Items
DescriptionItem
Media Access Control (MAC) address of the phone.MAC address
Host name that the DHCP server assigned to the phone.Host name
Name of the Domain Name System (DNS) domain in which the phone resides.Domain name
IP address of the Dynamic Host Configuration Protocol (DHCP) server from which
the phone obtains the IP address.
DHCP server
Indicates whether the phone obtains the configuration from a Bootstrap Protocol
(BootP) server.
BOOTP server
Indicates whether the phone uses DHCP.DHCP
Internet Protocol (IPv4) address of the phone.IP address
Subnet mask that the phone uses.Subnet mask
Default router used that the phone uses.Default router
Primary Domain Name System (DNS) server (DNS Server 1) and optional backup
DNS servers (DNS Server 2 and 3) that the phone uses.
DNS server 1–3
Indicates whether the phone is using an alternative TFTP server.Alternate TFTP
Primary Trivial File Transfer Protocol (TFTP) server used that the phone uses.TFTP server 1
Backup Trivial File Transfer Protocol (TFTP) server used that the phone uses.TFTP server 2
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
220
Cisco IP Phone Web Page
To Next Page
Loading...
Need help?
General
