Cisco 8811 Administration Guide

Set Park Monitoring Parameters for Directory Numbers
The Directory Number Configuration window contains a Park Monitoring area where you can configure the
three parameters.
Procedure
Step 1
In Cisco Unified Communications Manager Administration, choose Call Routing > Directory Number.
Step 2
Set the park monitoring fields as described in the following table.
Table 28: Park Monitoring Parameters
DescriptionField
When the parkee is an external party, the call forwards to the specified
destination in the parker Park Monitoring Forward No Retrieve Destination
External parameter. If the Forward No Retrieve Destination External field
value is empty, the parkee is redirected to the parker line.
Park Monitoring Forward
No Retrieve Destination
External
When the parkee is an internal party, the call forwards to the specified
destination in the parker’s Park Monitoring Forward No Retrieve Destination
Internal parameter. If the Forward No Retrieve Destination Internal is empty,
the parkee is redirected to the parker line.
Park Monitoring Forward
No Retrieve Destination
Internal
This parameter determines the number of seconds that Cisco Unified
Communications Manager waits before prompting the user to retrieve a call
that the user parked. This timer starts when the user presses Park on the phone,
and a reminder is issued when the timer expires.
Default: 60 seconds
If you configure a nonzero value, this value overrides the value of this parameter
set in the Service Parameters window. However, if you configure a value of
0 here, then the value in the Service Parameters window is used.
Park Monitoring Reversion
Timer
Set Up Park Monitoring for Hunt Lists
When a call that was routed via the hunt list is parked, the Hunt Pilot Park Monitoring Forward No Retrieve
Destination parameter value is used (unless it is blank) when the Park Monitoring Forward No Retrieve Timer
expires.
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
175
Phone Feature Configuration

Cisco 8811 Specifications

General

Ethernet Ports	2 x 10/100/1000
Lines Supported	5
Speakerphone	Yes
Headset Port	Yes
USB Port	No
Bluetooth	No
Wi-Fi	No
Resolution	800 x 480 pixels
PoE	Yes, IEEE 802.3af Class 2
Audio Codec Support	G.711, G.722, G.729, iLBC
Protocols	SIP
Display	5-inch, 800 x 480 pixels
Headset Jack	RJ9
Weight	1.1 kg