Cisco 8811

Configure Network Settings
If DHCP is not configured, configure these network settings on your phone after you install it on the network:
•
IP address
•
IP subnet information
•
IPv6 addresses
•
TFTP server IP address
If necessary, you may also configure the domain name and the DNS server settings.
The Ethernet Setup menu provides options for viewing and changing various network settings. The following
table describes these options and, where applicable, explains how to change them.
Establishing a VPN connection overwrites the Ethernet data fields.Note
Table 12: Ethernet Setup Menu Options
To changeDescriptionOption
Scroll to IPv4 Setup and press
Select.
See Set Up IPv4, on page 53.
In the IPv4 Setup configuration
submenu, you can do the following:
•
Enable or disable the phone to
use the IP address that the
DHCP server assigns.
•
Manually set the IP Address,
Subnet Mask, Default Routers,
DNS Server, and Alternate
TFTP servers.
This option displays only when the
phone is configured in IPv4-only
mode or in dual-stack mode.
IPv4 Setup
Scroll to IPv6 Setup and press
Select
See Set Up IPv6, on page 56.
The IPv6 configuration for the phone.IPv6 Setup
Display only. Cannot configure.Unique Media Access Control
(MAC) address of the phone.
MAC Address
See Set Domain Name Field, on
page 59.
Name of the Domain Name System
(DNS) domain in which the phone
resides.
Domain Name
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
50
Configure Network Settings