Cisco 8811 Administration Guide

DescriptionItem
Indication of whether streaming is active or not.Stream status
Unique, fixed name that is automatically assigned to the phone based on the
MAC address.
Host name
Total number of RTP data packets that the phone transmitted since it started
this connection. The value is 0 if the connection is set to receive-only mode.
Sender packets
Total number of payload octets that the phone transmitted in RTP data packets
since it started this connection. The value is 0 if the connection is set to
receive-only mode.
Sender octets
Type of audio encoding that is for the transmitted stream.Sender codec
Number of times the RTCP Sender Report has been sent.Sender reports sent
(see note)
Internal time-stamp indication as to when the last RTCP Sender Report was
sent.
Sender report time sent
(see note)
Total number of RTP data packets that have been lost since data reception started
on this connection. Defined as the number of expected packets less the number
of packets actually received, where the number of received packets includes any
that are late or are duplicates. The value displays as 0 if the connection was set
to send-only mode.
Rcvr lost packets
Estimate of mean deviation of the RTP data packet interarrival time, measured
in milliseconds. The value displays as 0 if the connection was set to send-only
mode.
Avg jitter
Type of audio encoding that is used for the received stream.Receiver codec
Number of times the RTCP Receiver Reports have been sent.Receiver reports sent
(see note)
Internal time-stamp indication as to when a RTCP Receiver Report was sent.Receiver report time sent
(see note)
Total number of RTP data packets that the phone has received since data
reception started on this connection. Includes packets that were received from
different sources if this call is a multicast call. The value displays as 0 if the
connection was set to send-only mode.
Rcvr packets
Total number of payload octets that the device received in RTP data packets
since reception started on the connection. Includes packets that were received
from different sources if this call is a multicast call. The value displays as 0 if
the connection was set to send-only mode.
Rcvr octets
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
230
Cisco IP Phone Web Page

Cisco 8811 Specifications

General

Ethernet Ports	2 x 10/100/1000
Lines Supported	5
Speakerphone	Yes
Headset Port	Yes
USB Port	No
Bluetooth	No
Wi-Fi	No
Resolution	800 x 480 pixels
PoE	Yes, IEEE 802.3af Class 2
Audio Codec Support	G.711, G.722, G.729, iLBC
Protocols	SIP
Display	5-inch, 800 x 480 pixels
Headset Jack	RJ9
Weight	1.1 kg