7-28
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Chapter 7 Configuring the ATM SPAs
Configuration Examples
Monitoring Per-Port Interface Statistics
Use the show controllers atm command to display detailed status and statistical information on a
per-port basis for an ATM SPA. The following example provides sample output for interface port 2 on
the ATM SPA that is located in subslot 2 of the SIP that is installed in slot 0 of a Cisco ASR 1000 Series
Router:
Router# show controllers atm 0/2/2
Interface ATM0/2/2 (SPA-3XOC3-ATM-V2[0/2]) is up
Framing mode: SONET OC3 STS-3c
SONET Subblock:
SECTION
LOF = 0 LOS = 1 BIP(B1) = 0
LINE
AIS = 0 RDI = 1 FEBE = 55 BIP(B2) = 0
PATH
AIS = 0 RDI = 1 FEBE = 21 BIP(B3) = 0
LOP = 1 NEWPTR = 0 PSE = 0 NSE = 0
Active Defects: None
Active Alarms: None
Alarm reporting enabled for: SF SLOS SLOF B1-TCA B2-TCA PLOP B3-TCA
ATM framing errors:
HCS (correctable): 0
HCS (uncorrectable): 0
APS
not configured
COAPS = 0 PSBF = 0
State: PSBF_state = False
Rx(K1/K2): 00/00 Tx(K1/K2): 00/00
Rx Synchronization Status S1 = 00
S1S0 = 00, C2 = 13
PATH TRACE BUFFER : STABLE
BER thresholds: SF = 10e-3 SD = 10e-6
TCA thresholds: B1 = 10e-6 B2 = 10e-6 B3 = 10e-6
Clock source: line
Configuration Examples
This section includes the following configuration examples for the ATM SPAs:
• Basic Interface Configuration Example, page 7-29
• MTU Configuration Example, page 7-29
• PVC on a Point-to-Point Subinterface Configuration Example, page 7-29
• PVC Ranges on a Multipoint Subinterface for PPPoEoA Configuration Example, page 7-30
• PVC Ranges on a Multipoint Subinterface for PPPoEoA Configuration Example, page 7-30
• AToM VP Cell Mode Relay Configuration Example, page 7-30
• PPPoEoA VC Class and PVC Range Configuration Example, page 7-30
• SONET and SDH Framing Configuration Example, page 7-31
To Next Page
Loading...
Need help?
General
