CHAPTER
4-1
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
4
Configuring the SIP
This chapter provides information about configuring the SIP on the Cisco ASR 1000 Series Routers. It
includes the following sections:
• Configuration Tasks, page 4-1
• Resetting a SIP, page 4-5
For information about managing your system images and configuration files, refer to other sections of
this document, and the Cisco IOS Configuration Fundamentals Configuration Guide and Cisco IOS
Configuration Fundamentals Command Reference publications that correspond to your Cisco IOS XE
software release.
Configuration Tasks
This section describes how to configure the SIP.
It includes the following topics:
• Identifying Slots and Subslots for the SIP and SPAs, page 4-1
• Hardware Module Scheduling Commands, page 4-3
Some of the Cisco IOS XE software features on the Cisco ASR 1000 Series Routers are supported on
the SIPs. Use this chapter while also referencing the list of supported features on the SIPs in
Chapter 3,
“Overview of the SIP.”
Note When referring to other platform documentation, be sure to note any SIP-specific configuration
guidelines described in this document.
Identifying Slots and Subslots for the SIP and SPAs
This section describes how to specify the physical locations of a SIP and SPA on the Cisco ASR 1000
Series Routers within the command-line interface (CLI) to configure or monitor the devices.
Specifying the Slot Location for a SIP
The Cisco ASR 1000 Series Routers support different chassis models, each of which supports a certain
number of chassis slots.
To Next Page
Loading...
Need help?
General
