21-6
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Chapter 21 Overview of the Cisco WebEx Node for ASR 1000 Series
Displaying the SPA Hardware Type
Displaying the SPA Hardware Type
To verify the SPA hardware type that is installed in your Cisco ASR 1000 Series Routers, you can use
the show interfaces service-engine or show hw-module subslot service-engine status command.
Table 21-1 shows the hardware description that appears in the show command output for each Cisco
WebEx node SPA that is supported on the Cisco ASR 1000 Series Routers.
Example of the show interface service-engine Command
The following example shows output from the show interfaces service-engine command on a Cisco
ASR 1000 Series Router with a Cisco WebEx Node SPA installed in subslot 0 of a SIP that is installed
in slot
0:
Router# show interfaces Service-Engine 0/0/0
Service-Engine0/0/0 is up, line protocol is up
Hardware is SPA-WMA-K9
Example of the show hw-module subslot service-engine status Command
The following example shows output from the show hw-module subslot service-engine status
command on a Cisco ASR 1000 Series Routers with a Cisco WebEx Node SPA installed in subslot 0 of
a SIP that is installed in slot 0:
Router# show hw-module subslot 0/0 service-engine status
Service Engine is Cisco SPA-WMA-K9
Ta b l e 21-1 Cisco WebEx Node SPA Hardware Descriptions in show Commands
SPA
Description in show interfaces
Command
Description in show hw-module subslot
Command
Cisco WebEx Node for ASR 1000 SPA “Hardware is SPA-WMA-K9” “Service Engine is Cisco
SPA-WMA-K9”
To Next Page
Loading...
Need help?
General
