Cisco ASR 1000 Configuration Guide

CHAPTER
15-1
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
15
Configuring the 8-Port Channelized T1/E1 SPA
This chapter provides information about configuring the 8-Port Channelized T1/E1 SPA on the Cisco
ASR 1000 Series Routers. It includes the following sections:
• Configuration Tasks, page 15-1
• Verifying the Interface Configuration, page 15-13
• Configuration Examples, page 15-14
For information about managing your system images and configuration files, refer to the Cisco IOS
Configuration Fundamentals Configuration Guide and Cisco IOS Configuration Fundamentals
Command Reference publications.
For more information about the commands used in this chapter, refer to the Cisco IOS Command
Reference publication for your Cisco IOS software release.
For more information, see the “Related Documentation” section on page xxvi.
Configuration Tasks
This section describes how to configure the 8-Port Channelized T1/E1 SPA for the Cisco ASR 1000
Series Routers and includes information about verifying the configuration.
It includes the following topics:
• Required Configuration Tasks, page 15-1
• Specifying the Interface Address on a SPA, page 15-6
• Optional Configurations, page 15-7
• Saving the Configuration, page 15-13
Required Configuration Tasks
This section lists the required configuration steps to configure the 8-Port Channelized T1/E1 SPA. Some
of the required configuration commands implement default values that might be appropriate for your
network. If the default value is correct for your network, then you do not need to configure the command.
• Setting the Card Type, page 15-2
• Enabling the Interfaces on the Controller, page 15-4
• Verifying Controller Configuration, page 15-5

Cisco ASR 1000 Specifications

General

Brand	Cisco
Model	ASR 1000
Category	Network Router
Language	English