Cisco ASR 1000 Configuration Guide

CHAPTER
22-1
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
22
Configuring the Cisco WebEx Node for ASR 1000
Series
This chapter provides information about configuring the Cisco WebEx Node for ASR 1000 Series on the
Cisco ASR 1000 Series Aggregation Services Routers, also referred to in this document as the Cisco
WebEx Node SPA. This chapter includes the following sections:
• Prerequisites, page 22-1
• Configuration Tasks, page 22-4
• Verifying the Service Engine Configuration, page 22-9
• Configuration Examples, page 22-10
For information about managing your system images and configuration files, refer to the Cisco IOS XE
Configuration Fundamentals Configuration Guide, Release 2 and Cisco IOS Configuration
Fundamentals Command Reference publications that correspond to your Cisco IOS XE software release.
Prerequisites
Complete the following prerequisites to successfully activate your Cisco WebEx Node for ASR 1000
Series:
• Registering with the WebEx Data Center and the Cisco WebEx Node Management System,
page 22-1
• Completing the Cisco WebEx Node SPA Configuration Prerequisites, page 22-4
Registering with the WebEx Data Center and the Cisco WebEx Node
Management System
To successfully activate a Cisco WebEx Node for ASR 1000 Series, certain registration and provisioning
activities must be performed with the WebEx Data Center using the Cisco WebEx Node Management
System. The Cisco WebEx Node Management System also provides monitoring and reporting for Cisco
WebEx nodes.
Once the SPA is registered with the WebEx Data Center, certain node security information must be
gathered and then configured on the Cisco WebEx Node for ASR 1000 Series.

Cisco ASR 1000 Specifications

General

Operating System	Cisco IOS XE
Interfaces	10 Gigabit Ethernet
Power Supply	AC or DC
Number of Total Expansion Slots	Varies by model
Management Port	Console
Redundant Power Supply Supported	Yes
Width	17.5 inches
Memory	Varies by model
Storage	Varies by model
Dimensions (H x W x D)	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	5% to 95% non-condensing
MTBF	Varies by model
Redundancy	Redundant power supplies, fans, and route processors (depending on model)