Cisco ASR 1000

10-35
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Chapter 10 Configuring the Ethernet SPAs
Configuration Examples
VLAN Configuration Example
The following example creates subinterface number 268 on SPA interface port 2 (the third port), and
configures the subinterface on the VLAN with ID number 268, using IEEE 802.1Q encapsulation:
! Enter global configuration mode.
!
Router# configure terminal
! Enter configuration commands, one per line. End with CNTL/Z.
!
! Specify the interface address
!
Router(config)# interface gigabitethernet 2/0/1.268
!
! Configure dot1q encapsulation and specify the VLAN ID.
!
Router(config-subif)# encapsulation dot1q 268