Cisco ASR 1000

13-12
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Chapter 13 Configuring the POS SPAs
Configuration Examples
LOP = 0 NEWPTR = 0 PSE = 0 NSE = 0
Active Defects: None
Active Alarms: None
Alarm reporting enabled for: SF SLOS SLOF B1-TCA B2-TCA PLOP B3-TCA
Framing: SONET
APS
COAPS = 0 PSBF = 0
State: PSBF_state = False
Rx(K1/K2): 00/00 Tx(K1/K2): 00/00
Rx Synchronization Status S1 = 00
S1S0 = 00, C2 = 00
Remote aps status (none); Reflected local aps status (none)
--More-- CLOCK RECOVERY
RDOOL = 0
State: RDOOL_state = False
PATH TRACE BUFFER: UNSTABLE
Remote hostname :
Remote interface:
Remote IP addr :
Remote Rx(K1/K2): / Tx(K1/K2): /
BER thresholds: SF = 10e-3 SD = 10e-6
TCA thresholds: B1 = 10e-6 B2 = 10e-6 B3 = 10e-6
Clock source: line
Configuration Examples
This section includes the following examples for configuring a POS SPA installed in a Cisco ASR 1000
Series Router:
• Basic Interface Configuration Example, page 13-13
• MTU Configuration Example, page 13-13
• POS Framing Configuration Example, page 13-14
• Keepalive Configuration Example, page 13-14
• CRC Configuration Example, page 13-14
• Clock Source Configuration Example, page 13-15
• SONET Payload Scrambling Configuration Example, page 13-15
• Encapsulation Configuration Example, page 13-15
• POS Alarm Trigger Delays Configuration Example, page 13-16