Cisco ASR 1000 Configuration Guide

2-5
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Chapter 2 SIP and SPA Product Overview
Modular Optics Compatibility
Modular Optics Compatibility
Some SPAs implement small form-factor pluggable (SFP) optical transceivers to provide network
connectivity. An SFP module is a transceiver device that mounts into the front panel to provide network
connectivity.
Cisco qualifies the SFP modules that can be used with SPAs.
Note The SPAs will only accept the SFP modules listed as supported in this document. An SFP module check
is run every time an SFP module is inserted into a SPA and only SFP modules that pass this check will be
usable.
Table 2-6, Table 2-7, Table 2-8, Table 2-9, Table 2-10 and Table 2-11 show the types of optics modules
that have been qualified for use with a SPA.
For more information about any of the supported transceivers for SPAs in these tables, refer to the Cisco
Transceiver Modules site for that module on Cisco.com at:
http://www.cisco.com/en/US/products/hw/modules/ps5455/prod_installation_guides_list.html
Ta b l e 2-6 ATM SPA Optics Compatibility
SPA Qualified Optics Modules (Cisco Part Numbers)
1-Port Clear Channel OC-3 ATM
SPA
• SFP-OC3-MM
• SFP-OC3-IR-1
• SFP-OC3-LR-1
3-Port Clear Channel OC-3 ATM
SPA
• SFP-OC3-MM
• SFP-OC3-IR-1
• SFP-OC3-LR-1
1-Port Clear Channel OC-12 ATM
SPA
• SFP-OC12-MM
• SFP-OC12-SR
• SFP-OC12-IR1
• SFP-OC12-LR1
• SFP-OC12-LR2

Cisco ASR 1000 Specifications

General

Operating System	Cisco IOS XE
Interfaces	10 Gigabit Ethernet
Power Supply	AC or DC
Number of Total Expansion Slots	Varies by model
Management Port	Console
Redundant Power Supply Supported	Yes
Width	17.5 inches
Memory	Varies by model
Storage	Varies by model
Dimensions (H x W x D)	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	5% to 95% non-condensing
MTBF	Varies by model
Redundancy	Redundant power supplies, fans, and route processors (depending on model)