Cisco ASR 1000

12-5
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Chapter 12 Overview of the POS SPAs
Restrictions
Restrictions
Note For other SIP-specific features and restrictions see also Chapter 3, “Overview of the SIP”.
Table 12-1 provides information about POS feature compatibility and restrictions by SIP and SPA
combination.
Supported MIBs
The following MIBs are supported for the POS SPAs on the Cisco ASR 1000 Series Routers:
• CISCO-ENTITY-ASSET-MIB
• CISCO-ENTITY-FRU-CONTROL-MIB
• CISCO-ENVMON-MIB (For NPEs, NSEs, line cards, and MSCs only)
• CISCO-EXTENDED-ENTITY-MIB
• CISCO-OPTICAL-MIB
• ENTITY-MIB
• OLD-CISCO-CHASSIS-MIB
• IF-MIB
• SONET-MIB (RFC 2558, Definitions of Managed Objects for SONET/SDH Interface Type)
• MIB II
To locate and download MIBs for selected platforms, Cisco IOS releases, and feature sets, use
Cisco
MIB Locator found at the following URL:
http://tools.cisco.com/ITDIT/MIBS/servlet/index
If Cisco MIB Locator does not support the MIB information that you need, you can also obtain a list of
supported MIBs and download MIBs from the Cisco
MIBs page at the following URL:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
To access Cisco MIB Locator, you must have an account on Cisco.com. If you have forgotten or lost your
account information, send a blank e-mail to cco-locksmith@cisco.com. An automatic check will verify
that your e-mail address is registered with Cisco.com. If the check is successful, account details with a
new random password will be e-mailed to you. Qualified users can establish an account on Cisco.com
by following the directions found at this URL:
http://www.cisco.com/register
Ta b l e 12-1 POS Feature Compatibility and Restrictions by SIP and SPA Combination
Feature Cisco ASR1000-SIP10
Bridge Control Protocol (BCP) Not supported on any POS SPAs.
Dynamic Packet Transport (DPT), which includes
RPR/SRP
Not supported on any POS SPAs.
Frame Relay Supported on all POS SPAs.