EasyManuals Logo
Home>Cisco>Network Router>ASR 1000

Cisco ASR 1000 Configuration Guide

Cisco ASR 1000
442 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #362 background imageLoading...
Page #362 background image
22-10
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Chapter 22 Configuring the Cisco WebEx Node for ASR 1000 Series
Configuration Examples
Note Since the passcode and token are encrypted, the actual content is not displayed.
Verify that the service engine is reported in “Steady” state, and the Application Status is “Online.” If the
Application Status is “Online,” then verify that the indicated operation mode (“Web Conferencing” or
“Voice and Video Conferencing”) is correct. If not, contact Cisco WebEx Technical Support to correct
the problem.
If the Application Status field is “Offline” then the operation mode (indicated in parenthesis in
"Application" field) will show that it is not configured, as shown in the following sample output:
Router# show hw-module subslot 1/0 service-engine status
Service Engine is Cisco SPA-WMA-K9
Service Engine state: Steady (0x300)
Service Engine OS Version: 1.0.0, Application Version: 1.0.0
Application: WebEx Node (operation mode not configured)
Application Status: Offline
This occurs when the connection to the Cisco WebEx Data Center fails, and therefore provisioning
information about the operation mode can not be retrieved. For more information about provisioning,
see the
“Registering with the WebEx Data Center and the Cisco WebEx Node Management System”
section on page 22-1. For additional troubleshooting information, refer to Chapter 23, “Troubleshooting
the Cisco WebEx Node for the ASR 1000 Series.
Configuration Examples
This section includes an example for configuring a Cisco WebEx Node SPA installed in a Cisco ASR
1000 Series Router:
Router# config t
Router(config)# interface service-engine 1/0/0
Router(config-if)# ip address 10.200.72.17 255.255.255.252
Router(config-if)# service-engine ip address 10.200.72.18 255.255.255.252
Router(config-if)# service-engine default-gateway 10.200.72.17
Router(config-if)# service-engine nameserver 10.100.4.10 10.100.4.20
Router(config-if)# service-engine hostname spawma1 cisco.com
Router(config-if)# service-engine wma-url https://wmabts.webex.com/wmams
Router(config-if)# service-engine wma-passcode spawma1 2b51221d2c08f405913bbee1eb9f6ec6
Router(config-if)# service-engine wma-token 45484b3e-8ea5-41e5-b050-49409006d14e
Router(config-if)# no shutdown

Table of Contents

Other manuals for Cisco ASR 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 1000 and is the answer not in the manual?

Cisco ASR 1000 Specifications

General IconGeneral
BrandCisco
ModelASR 1000
CategoryNetwork Router
LanguageEnglish

Related product manuals