Cisco ASR 1000

CHAPTER
10-1
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
10
Configuring the Ethernet SPAs
This chapter provides information about configuring the Fast Ethernet and Gigabit Ethernet SPAs and
on the Cisco ASR 1000 Series Router. It includes the following sections:
• Configuration Tasks, page 10-1
• Verifying the Interface Configuration, page 10-15
• Using show Commands to Check SFP Module and XFP Module Status, page 10-16
• Configuring the Network Clock for the 2-Port Gigabit Synchronous Ethernet SPA on a Cisco ASR
1000 Series Router, page 10-19
For more information about the commands used in this chapter, refer to the related Cisco IOS software
command reference and master index publications and the publication that corresponds to your Cisco
IOS XE software release. For more information about accessing these publications, see the
“Related
Documentation” section on page xxvi.
For information about managing your system images and configuration files, refer to the Cisco ASR 1000
Series Aggregation Services Routers Software Configuration Guide, the Cisco IOS Configuration
Fundamentals Configuration Guide, and the Cisco IOS Configuration Fundamentals Command
Reference publications that correspond to your Cisco IOS software release.
Configuration Tasks
This section describes how to configure the Gigabit Ethernet and Fast Ethernet SPAs and includes
information about verifying the configuration.
This section includes the following topics:
• Required Configuration Tasks, page 10-2
• Specifying the Interface Address on a SPA, page 10-4
• Modifying the MAC Address on an Interface, page 10-4
• Gathering MAC Address Accounting Statistics, page 10-5
• Configuring the Hot Standby Router Protocol, page 10-5
• Modifying the Interface MTU Size, page 10-6
• QoS Classification, page 10-7
• Configuring the Encapsulation Type, page 10-10
• Configuring the Autonegotiation on an Interface, page 10-10