Cisco ASR 1000 Configuration Guide

CHAPTER
17-1
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
17
Configuring the 2-Port and 4-Port Clear Channel
T3/E3 SPAs
This chapter provides information about configuring the 2-Port and 4-Port Clear Channel T3/E3 SPAs
on the Cisco ASR 1000 Series Routers. It includes the following sections:
• Configuration Tasks, page 17-1
• Verifying the Interface Configuration, page 17-16
• Configuration Examples, page 17-18
For information about managing your system image and configuration files, refer to the Cisco IOS
Configuration Fundamentals Configuration Guide and Cisco IOS Configuration Fundamentals
Command Reference publications for your Cisco IOS software release.
For more information, see the “Related Documentation” section on page xxvi.
Configuration Tasks
This section describes how to configure the 2-Port and 4-Port Clear Channel T3/E3 SPA for the Cisco
ASR 1000 Series Routers and includes information about verifying the configuration.
It includes the following topics:
• Required Configuration Tasks, page 17-2
• Specifying the Interface Address on a SPA, page 17-5
• Optional Configurations, page 17-5
• Saving the Configuration, page 17-16

Cisco ASR 1000 Specifications

General

Operating System	Cisco IOS XE
Interfaces	10 Gigabit Ethernet
Power Supply	AC or DC
Number of Total Expansion Slots	Varies by model
Management Port	Console
Redundant Power Supply Supported	Yes
Width	17.5 inches
Memory	Varies by model
Storage	Varies by model
Dimensions (H x W x D)	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	5% to 95% non-condensing
MTBF	Varies by model
Redundancy	Redundant power supplies, fans, and route processors (depending on model)