Cisco ASR 1000 Configuration Guide

15-2
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Chapter 15 Configuring the 8-Port Channelized T1/E1 SPA
Configuration Tasks
• Setting the IP Address, page 15-6
• Verifying Interface Configuration, page 15-6
Note To better understand the address format used to specify the physical location of the SIP, SPA, and
interfaces, see the “Specifying the Interface Address on a SPA” section on page 15-6.
Setting the Card Type
The SPA is not functional until the card type is set. Information about the SPA is not indicated in the
output of any show commands until the card type has been set. There is no default card type.
Note Mixing of interface types is not supported. All ports on a SPA must be of the same type.
To set the card type for the 8-Port Channelized T1/E1 SPA, complete these steps:
Command Purpose
Step 1
Router# configure terminal Enters global configuration mode.

Cisco ASR 1000 Specifications

General

Brand	Cisco
Model	ASR 1000
Category	Network Router
Language	English