Cisco ASR 1000

18-5
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Chapter 18 Configuring the 4-Port Serial Interface SPA
Configuration Tasks
Slot Type State Insert time (ago)
--------- ------------------- --------------------- -----------------
0 ASR1002-SIP10 ok 5d04h
0/0 4XGE-BUILT-IN ok 5d04h
0/1 SPA-4XT-SERIAL ok 4d05h
0/2 SPA-4XT3/E3 ok 4d04h
0/3 SPA-8XCHT1/E1 ok 4d04h
R0 ASR1002-RP1 ok, active 5d04h
F0 ASR1000-ESP5 ok, active 5d04h
P0 ASR1002-PWR-AC ok 5d04h
P1 ASR1002-PWR-AC ok 5d04h
Slot CPLD Version Firmware Version
--------- ------------------- ---------------------------------------
0 07092701 12.2(33r)XN2
R0 07100216 12.2(33r)XN2
F0 07091401 12.2(33r)XN2
The following is an example of the show running-config command with the 4-Port Serial Interface SPA:
Router# show running-config serial
Building configuration...
Current configuration : 54 bytes
!
interface Serial2/0/0
no ip address
shutdown
end
The following is an example of the show running interface command with the 4-Port Serial Interface
SPA:
Router# show running interface ser2/0/1
Building configuration...
Current configuration : 54 bytes
!
interface Serial2/0/1
no ip address
shutdown
end
The following is an example of the show startup-config command with the 4-Port Serial Interface SPA:
Router# show startup-config | b Serial2/0/0
interface Serial2/0/0
no ip address
shutdown
!
interface Serial2/0/1
no ip address
shutdown
!
interface Serial2/0/2
no ip address
shutdown
!
interface Serial2/0/3
no ip address
shutdown
!