Cisco ASR 1000

IN-4
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
troubleshooting 26-9
FPDs
description 26-1
framing, configuring 15-8, 16-13, 17-11
G
giant packets 7-5
Gigabit Ethernet SPAs
configuring 10-1
features supported 9-2
MAC address 10-4
modifying MTU 10-6
QoS 10-7
SPA automatic recovery 11-6
troubleshooting 11-1
using show commands 10-16
VLAN 10-12
global configuration mode, summary of 1-6
H
hardware platforms
See platforms, supported
help command 1-7
Hot Standby Router Protocol . See HSRP.
HSRP, verifying configuration 10-5
hw-module slot start command 5-4, 5-9
hw-module slot stop command 5-3
hw-module sublsot start | stop | relaod command 5-3
hw-module subslot command 10-15
hw-module subslot shutdown command 5-7, 5-8, 5-9
I
IEEE 802.1Q encapsulation 10-10
configuration (example) 10-35
configuring 10-12
images
FPD 26-2
upgrading 26-2
upgrading multiple FPD 26-2
interface
basic configuration (example) 10-33
enabling 10-3
restarting 10-15
shutting down 10-15
verifying configuration 10-15 to 10-16
interface address, specifying 10-4
interface configuration mode, summary of 1-6
interface gigabitethernet command 10-2, 10-13, 22-5
interface status line - states, show interfaces serial
command
20-3
interface tengigabitethernet command 10-2, 10-13
invert the data stream 15-11
ip address command 10-2, 10-13
K
keyboard shortcuts 1-5
L
lines - interface status 20-3
lines - states, show interfaces serial command 20-3
loopback command 8-6