Cisco ASR 1000

Contents
vi
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
OL-14127-08
Verifying a Multipoint PVC Configuration 7-14
Configuring a Range of PVCs on a Multipoint Subinterface 7-15
Configuring Traffic Parameters for PVCs 7-17
Verifying the Traffic Parameter Configuration 7-19
Configuring Virtual Circuit Classes 7-20
Verifying the Virtual Circuit Class Configuration 7-21
Configuring SONET and SDH Framing 7-21
Verifying the SONET and SDH Framing Configuration 7-22
Configuring AToM VP Cell Mode Relay Support 7-23
VP Mode Configuration Guidelines 7-23
VP Mode Configuration Example 7-23
Verifying ATM Cell Relay VP Mode 7-24
Configuring QoS Features on ATM SPAs 7-24
Configuring PPPoEoA on ATM SPAs 7-24
Saving the Configuration 7-25
Shutting Down and Restarting an Interface on a SPA 7-25
Verifying the Interface Configuration 7-27
Verifying Per-Port Interface Status 7-27
Monitoring Per-Port Interface Statistics 7-28
Configuration Examples 7-28
Basic Interface Configuration Example 7-29
MTU Configuration Example 7-29
PVC on a Point-to-Point Subinterface Configuration Example 7-29
PVC Ranges on a Multipoint Subinterface for PPPoEoA Configuration Example 7-30
AToM VP Cell Mode Relay Configuration Example 7-30
PPPoEoA VC Class and PVC Range Configuration Example 7-30
SONET and SDH Framing Configuration Example 7-31
CHAPTER 8 Troubleshooting the ATM SPAs 8-1
General Troubleshooting Information 8-1
Interpreting Console Error and System Messages 8-1
Using debug Commands 8-2
General debug Commands 8-2
ATM debug Commands 8-2
Using show Commands 8-2
Performing Basic Interface Troubleshooting 8-3
Using the Ping Command to Verify Network Connectivity 8-4
Displaying Additional ATM SPA Data 8-5
Displaying ATM SPA Hardware Information 8-5