Cisco Catalyst 2950

2-75
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
cpe speed
This example shows how to set port 1 to 10 Mbps, port 2 to 100 Mbps, and the remainder of the ports to
autonegotiate.
Switch# configure terminal
Switch(config)# interface longreachethernet0/4
Switch(config-if)# cpe speed auto
Switch(config-if)# cpe speed 10 port 1
Switch(config-if)# cpe speed 100 port 2
This example shows how to set port 1 to autonegotiate after the cpe speed 10 command is entered:
Switch(config-if)# no cpe speed 10 port
Related Commands Command Description
local duplex Sets the port speed for LRE ports.
show interfaces cpe Displays connection, speed, and duplex settings for CPE Ethernet ports
attached to the specified LRE switch port