Cisco Catalyst 2950 Command Reference

B-9
Catalyst 2950 and Catalyst 2955 Switch Command Reference
OL-10102-01
Appendix B Catalyst 2950 and 2955 Switch Boot Loader Commands
flash_init
flash_init
Use the flash_init boot loader command to initialize the flash file system.
flash_init
Syntax Description This command has no arguments or keywords.
Defaults The flash file system is automatically initialized during normal system operation.
Command Modes Boot loader
Command History
Usage Guidelines During the normal boot process, the flash file system is automatically initialized.
Use this command to manually initialize the flash file system. For example, you use this command
during the recovery procedure for a lost or forgotten password.
Release Modification
12.1(11)YJ This command was introduced.

Cisco Catalyst 2950 Specifications

General

Forwarding Bandwidth	8.8 Gbps
Switching Capacity	13.6 Gbps
Forwarding Rate	6.6 Mpps
Weight	3.6 kg
RAM	16 MB
Flash Memory	8 MB
Operating Humidity	10% to 85% non-condensing
Uplink Ports	2 x 10/100/1000Base-T
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Remote Management Protocol	SNMP, Telnet, HTTP
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p
Status Indicators	system
Operating Temperature	0 to 45°C
Ports	24 x 10/100 Ethernet ports
MAC Address Table Size	8, 192 entries
Power Supply	Internal 100-240V AC, 50-60Hz